What Rotary Cultivator Is The Common Problem

1, rotary cultivator load is too large. Often because of the deep or tilled soil heavy, hard, can reduce the tillage depth, reduces the speed and coulter revolutions.

2, rotary cultivator at work. This is because the soil is hard or the blade installation is not normal, can decrease the speed of unit and coulter speed, blade and properly installed.

3, rotary cultivator discontinuous throw big clods. This is due to the blade bending deformation, broken, lost, or caused serious wear and tear, correction or replacement of the blade.

After 4, rotary tillage uneven ground. This is due to improper unit speed cooperate with knife shaft speed, can adjust the speed between the two.

5, coulter gearbox noise. Common causes of foreign bodies in the gearbox or with installation bearing, gear teeth seriously damaged, need to remove foreign bodies or replace the damaged bearings or gears.

6, rotary cultivator work metal tapping. Main reasons are: transmission after the chain too loose and casing scratches, colter shaft on both ends of the blades, left arm or body deformation after colliding, loose or blade fixed screw, etc., can be adjusted to check transmission chain length tightness, correction or replacement of severe deformation of parts, tighten the loose screw.

7, rotary tiller coulter pivot. This is because the gear or bearing killed, left arm or drive casing deformation, colter shaft bending deformation, transmission chain is broken, or colter shaft winding grass mud wall due to reasons such as the serious, correction, repair, replacement, serious deformation of the damaged parts, remove the winding grass mud.