Rotary Cultivator Matters Needing Attention During Operation

1, homework, rotary cultivator should be in a state of ascension, combined with the power output shaft first, make the knife shaft speed increased to rated speed, and then drop rotary cultivator, make blade gradually the grave to the required depth. Blade is forbidden the grave after a sharp drop in combined with the power output shaft or rotary cultivator, lest cause blade bend or break and increase the load on the tractor.

2, in operation, should as far as possible low speed slow, so that can ensure the quality of work, make the clod and finely, and reduce the wear and tear parts. Should pay attention to listen to the rotary cultivator any noise or metallic sound, and observation of ground soil, deep tillage. If there is any exception should immediately stop check, eliminate rear can continue to work.

3, in the field when they turn to ban homework, rotary cultivator should be raised, the blade out of the ground, and reduce the size of the tractor accelerator, so as not to damage the blade. Promote rotary cultivator, universal joint, the slope Angle of the operation should be less than 30 degrees, too big will impact noise, make its premature wear or damage.

4, in reverse, ridge, and transfer land, rotary cultivator should be promoted to the highest position, and cut off the power, so as not to damage parts. As to the distant metastases, should fix the rotary cultivator with locking devices.

5, homework, every shift should make maintenance for the rotary cultivator. Clear the dirt on the blades and weeds, and check the connector fastening, lubricating oil into all lubricating points listed, and the universal joint filling butter, in case of increase the wear and tear.