Rotary cultivator and tractor collaboration

Rotary cultivator is complete tillage with tractor kit, harrow tillage machinery, have strong ground soil, till after the surface flat etc., has been widely used. Proper use and adjust the rotary cultivator, keep the good technical state, is crucial to ensure the quality of cultivation, then teach you how to make the rotary cultivator and tractors with good job, perfect collaboration.

1, install the blade. There are three common installation methods, namely the installation method, introversion extroversion installation method and the staggered installation method, introverted installed around the curved knife to the middle of the knife shaft bending, this kind of installation method plow out of the land, till one of picture of ridge, before is very suitable for field work, also can make the cross ditch work unit, fill channel effect; Outgoing installation method about machete to bend on both ends of the knife shaft, shaft on the outside of the knife into the corner, this method of farming in the middle of a plow picture, is suitable for open field cultivation or trenching rotary joint operation; Finally is staggered installation method, this method of farming plow out of the ground is flat, is a very common installation methods, curved blade on the knife shaft cross symmetry around installation, left, right outside the knife shaft end a knife to bend.

2, connect installation. Specific process is as follows, to cut off the tractor pto first, and then take the shaft cover cap, after reversing articulated knife rotary cultivator, finally put the universal joint with a square shaft into the shaft of rotary cultivator, lift rotary cultivator later turn the knife shaft by hand, check the flexibility, then take the set of universal joint set into the tractor pto shaft is fixed.

3, before the adjustment. Control before and after the first adjustment, under the rotary cultivator, later to plow deep to see the outgoing section Angle, adjust the tractor hitch system on the pull rod, let the universal joint in a horizontal position, hold pillow in the universal joint can work in optimum conditions. Around and then adjust the level, the rotary cultivator is reduced, the point on the ground, watching the height of the two point is the same, if you don't like to adjust the height of the hanging rod, the tip can guarantee about tillage depth is consistent.

4, adjusted before use. Adjustment on the properties of ground soil, for example, the stand or fall of ground soil properties is closely related with the tractor forward speed and knife shaft speed, knife shaft speed must be, if the speed to speed up the tractor and plow the clods will be big, instead will become smaller; Soil dragging plate location of change also affects soil effect, can according to actual needs, fixed grading dragging plate location.